[Rod-End Side]

1 Insert 4 M3x8 screw into the middle hole of U-type Bracket and fix the screw to the user’s device. Align the center of the two side holes of U-type Bracket and the side hole of Rod, then insert 2 Hinge-pin. After the Hinge-pin protrudes from both ends of U-Bracket, fix the pin by two 3 E-rings.

[Rear Case Side]

1Insert 4M3x8 screw into the middle hole of U-type Bracket and fix the screw to the user’s device. Align the center of the two side holes of U-type Bracket and the side hole of Hinge on the rear case, then insert 2Hinge-pin. After the Hinge-pin protrudes from both ends of U-Bracket, fix the pin by two 3E-rings.
* Cuation : Either Rod or Rear case hinge must be mechanically unconstrained and must be structured to move freely along with the actuator.

[F-PCB]

Insert the Terminal of F-PCB so that it can make contact with the 5connector pin. (See the picture below)
if inserted in the opposite direction, the actuator will not work.